J-Dream Owner’s Manual
Attach Hoses for Hot and Cold Water Lines and Control Cable, Ground Wire
The hoses are marked to indicate where they are to be tied on the side of the back wall. This is to allow the proper
slack when the hinged seat wall is swung open (like a door) to access equipment. The hot and cold water lines are
to go behind the steam line. Connect lines A, B, and C at the corresponding letters on the mixer. Also connect hot
and cold water supply hoses. Connect control cable. Connect ground wire (yellow with green stripe) to terminal on
mixer valve.
21
C
AB
A
C
B
C
AB
Hot Water Line (with
braided metal sheathing)
Cold Water Line (with
braided metal sheathing)
Line A (with braided
metal sheathing)
Control
Cable
Line B (use hot
water to ease
connection)
Bond wire from seat wall to
be clipped to mixer here
Line C (use hot water
to soften the hose to
ease installation over
the barbed fitting)
Bond wire
Bonding post
To Next Page
Loading...
