Jacuzzi J-DREAM - Panel Installation Procedures

J-Dream Owner’s Manual
12
Installation of Panels (Note: Right hand J-Dream with stereo shown
throughout this manual except where noted.)
Attach Seat Wall to Base
Bolts (8)
Nuts (8)
G
J
Align four holes on seat
wall frame over base and
insert bolts and tighten
nuts from underneath.
Washers (8)
I
Equipment
Seat Wall
Pan lip
Pan floor
Install clip over pan lip locating it over cut-
out in seat wall and secure with foam tape
(pre-installed on clip). Reservoir over flow
drain hose will be fed through the clip.
Clip (1)
Drain line
Bolts (2)
G
Nuts (8)
J
Frame
Align holes on bracket with
frame holes and insert bolts
and tighten nuts.
B
A
C
B
A
C
Spacer
Bracket (2)
90° (See Note)
Note: Check to see that
the seat wall frame vertical
leg is perpendicular to base
frame. If necessary, use
1/4" flat washer C to shim
the seat wall frame.