44
Radio (optional)
I Turn on the remote control by pressing the key : The dis-
play will show the Jacuzzi logo and moving bubbles.
Turning on the radio
I (fig. 28) Then press the key : The display w ill show an
icon for the radio function, with the cursor flashing on the mes-
sage I/O.
I Make sure you are aiming the remote control at the receiver,
as shown in the figure, and press the key . The radio will come
on, and it will show the last frequency it was tuned to.
• If tuning is not possible when the radio is turned on, the dis-
play will show the message “NO RX”. Refer to the paragraph
on tuning.
• If the remote control is not used for about 1 minute, the display
panel light gradually fades until it goes out; press any button to
start it again.
Adjusting the volume
I Use the keys or respectively to increase or de-
crease the volume.
Frequency adjustment
I (fig. 29) The radio includes an automatic system for search-
ing for transmitting stations. To activate it, proceed as follows:
- Use the keys or to place the flashing cursor on
SEEK.
- Aim the remote control at the receiver and do the following:
• press the key to start searching for stations that are
broadcasting on frequencies that are higher than the one
currently in use.
• press the key to go back to the frequency immedi-
ately previous to the one currently in use.
Frequency memorization
I (fig. 3 0) It is possible to memorize 3 different frequencies
by doing the following:
NOTE
1
32
3
40°C
16:30
40°C
16:30
MEM 3
MEM 2
MEM 1
SEEK
103
VOLUME
2 3
40°C
16:30
MEM 3
MEM 2
MEM 1
SEEK
103
VOLUME
1
2
1
28
29
To Next Page
Loading...
Need help?
General
