10
Tap fixtures
I (fig. 4) The tap fixtures are located on the side of the tub
and include:
•(A) Drain column control
When turned clockwise, the tub drain is closed.
•(B) Shower head
(fig. 5) To extract it, press on the ring nut and turn as indicat-
ed, and with the other hand pull the grip up. Do the same thing
to retract the hose and to put the shower head back in place.
•(C) Spout
Fills tub with water; (fig. 6) to send water to the shower head,
raise the indicated lever. After using the tub, make sure the
lever is down.
Preliminary operations
FILLING
I Before filling the tub, make sure that the lever on the rear of
the spout is down (fig. 6); to make it easier to get into and out
of the tub, the spout can be turned in two directions, as sho wn.
I Then use the knobs to control the temperature of the water.
Once you are in the tub, the water must completely cover the
outlets located on the back.
I Provide power using the switch installed on the tub's power sup-
ply line.
SOME SUGGESTIONS
I (fig. 7) Also make sure that the hydromassage jets are point-
ing towards the parts of the b ody that you wish to massage;
this can be achieved by simply moving the nozzle.
The jets on the back are not directionally adjustable.
I (fig . 8) You can also vary the intensity of the hydromassage
cycle by adjusting the hydromassage outlet nozzles situated
along the edge of the tub, until one or more jets are complete-
ly closed.
The jets on the back are not directionally adjustable.
I The length of the hydromassage cycle and the water tem-
perature are, however, matters of personal p reference, related
to the type of treatment and the physical condition or habits of
the individual. Here are some recommendations:
AB C D E
4
5
6
To Next Page
Loading...
Need help?
General
