Jacuzzi Muse - Shiatsu

34
T
he Shiatsu hydromassage works thanks to a series of
microjets positioned along the "vu" meridian which ac-
cording to Chinese medicine provides energy from the back
to the entire body; the microjets are positioned so that they
make contact and activate all the cervical, dorsal and lum-
bar points.
QThe Shiatsu hydromassage operates in two modes:
- relax (relaxation) with a top to bottom sequence;
- tonic (tone up) with a bottom to top sequence.
QFill the tub, turn on the main switch and hold down the key displayed until the function keys
come on (the battery charge level and value - indicative of the water temperature - are also
briey presented).
35
35
QHold down the “relax” or “tonic” keys (respectively, relaxing or toning massage): the
key will ash, indicating that the start-up procedure is underway.
When the ashing stops and the light becomes brighter, the function starts.
relax
tonic
35 35
QThe intensity progressively increases automatically, however it can be adjusted as de-
sired by holding down the “+” or “–” key (the LED light will ash briey); in any case, after a
certain time, the intensity will vary based upon the characteristic trend of the programme
selected.
35
programme
activation
varying the
hydromassage intensity
If the remote control
fails to activate or
where the smallest
LED light ashes
, the battery must be
charged (refer to the Chapter.
"Charg-
ing the J.touch remote control")
Once on, the J.touch remote control,
where not used, switches o after
about 15 seconds; to turn it on again,
lightly shake it
The “relax” and “tonic” programmes
are activated at preset intensity levels:
- relax: medium intensity (2 LED lights on)
- tonic: minimum intensity (1 LED light on)
To change programmes, simply press
the relative key (you must wait a few
seconds before the start-up)
It is possible to adjust the intensity ac-
cording to ten levels, divided as follows:
Shiatsu
(relax/tonic)
0 - 2
3 - 5
6 - 9