Jacuzzi Muse - Troubleshooting; Hydromassage Does Not Start; The Hydromassage Stops of Its Own Accord; The Strength of the Hydromassage Has Got Weaker

46
Troubleshooting...
lack of electric energy
command not accepted
insucient water level
possible distributor fault
possible electrical box fault
L1
P1
P3
P2
;;
EI
lack of electric energy
the selected hydromassage pro-
gramme is nished (each programme
has its own duration, after which time,
the hydromassage stops on its own)
insucient water level
L1
- check that the main switch is not o and/
or that the system is not faulty (contact your
trusted electrician)
- try to keep the key on the remote control held
down again (also follow the instructions in the
relative chapters)
- add water to the level where, once immersed,
it covers the highest nozzles on the backrest
and once again, hold down the key
- switch o the tub and contact a Jacuzzi® Sup-
port Centre
- switch o the tub and contact a Jacuzzi® Sup-
port Centre
- check that the main switch is not o and/
or that the system is not faulty (contact your
trusted electrician)
- where desired, re-start the hydromassage (re-
fer to the relative chapter)
- add water within about 5 minutes from the
appearance of the warning (the function will
resume automatically); where this is not the
case, the function will be denitively reset
Hydromassage
does not start
The hydromassage stops
of its own accord
W
e always recommend carefully reading the manual before using your tub; in the in-
stance that there is an issue, refer to the following guide.
Some operation faults are presented on the J.touch remote control display with codes.
the outlet nozzles are closed
poor hydromassage intensity
obstructed air outlets and/or hydro-
massage
- open the nozzles (refer to Chapter “prelimi-
nary operations - some recommendations”)
- use "+" on the remote control, as indicated in
the relative chapters.
- clean the outlets as described in the Chap-
ter “Maintenance”; where this is not sucient,
contact a Jacuzzi® Support Centre.
The "strength" of the hydromas-
sage has got weaker; not many
air bubbles come out of the
larger hydromassage outlets
In addition to the faults listed in the
"hydromassage does not start", sec-
tion, refer to the below described
(*) the code does not
appear when the remote
control is in stand-by
*