27
USE & MAINTENANCE
Functions
Shower head (pos. A, see “Use of functions”)
Shower blowpipe (pos. B)
located in the upper part, creates a generous rainfall jet.
Vertical hydromassage (pos. C and D)
equipped with 4 simultaneous water jets that come out of the noz-
zles on the wall.
Jets can be tilted in four directions, by pressing the nozzle and mov-
ing it to the required position.
Use of functions
GENERAL NOTES:
Never use water at a temperature of over 60 °C, to prevent
damage to the plumbing circuit.
NOTE: It is also possible to use two functions at the same time. Just
position the diverter dial half way between the two func-
tions.
THERMOSTATIC TAP FIXTURES
Before you use any function, you should adjust the water tempera-
ture to the value you want by doing the following:
Turn the dial (M) so that the notch matches up with the cho-
sen value. The knob is provided with a safety lock that fixes the
temperature at 38°C; to select higher temperatures, push the
button (P).
If you wish to try the water temperature, turn the diverter di-
al (G) to the "showerhead" (A) position and turn the stop tap (R)
to let water come out.
Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the function you want
to use
Remember to turn off the stop tap every time after use (R). If tempera-
tures above 38 °C have been selected, it is advisable to turn back the
thermostatic mixer dial to the position before the safety lock.
To Next Page
Loading...
Need help?
General
