EasyManua.ls Logo

Jacuzzi SWIMSPA Power Actve J16

Jacuzzi SWIMSPA Power Actve J16
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
10. Cool Warning: Swim spa water is more than 20
o
F / 11
o
C cooler than the temperature set
point , the circulaon pump and heater will automacally acvate to provide freeze pro-
tecon. The swim spa will stay in this mode unl the water temperature reaches 14
o
F /
8
o
C below the set temperature. No correcve acon is necessary.
Note: The heater icon will be blinking and the error icon will be displayed under the
temperature.
11. Freeze protecon: A potenal freeze condion has been detected. No acon is required.
Jet pump(s) operate unl the swim spa is out of danger. No correcve acon is neces-
sary. If condion persists, contact your authorized dealer or service organizaon.
12. Overheat protecon: DO NOT ENTER THE WATER! Water temperature is above accepta-
ble limits. Heater is deacvated. Remove swim spa cover to speed cooling. If condion
persists, contact your authorized dealer or service organizaon.
Note:
As a safety measure, the red lights of the swim spa will flash on and off as an indica-
on that the swim spa is in an overheat condion.
The heater icon will be blinking and the error icon will be displayed under the tem-
perature.
WARNING: RISK OF HYPERTHERMIA (OVERHEATING) CAUSING SEVERE
INJURY, BURNS OR WELTS.
13. Controller Overheat Protecon: Controller temperature has exceeded acceptable limits.
If condion persists, provide shade for equipment side of swim spa. Contact your author-
ized dealer or service organizaon.
Note: The heater icon will be blinking and the error icon will be displayed under the
temperature.
14. Panel Com Error: The topside controller is having trouble communicang to your swim
spa. Contact your authorized dealer or service organizaon.
15. CLEARRAY Replacement Reminder: This message will appear when the CLEARRAY bulb
reminder me has expired. The CLEARRAY bulb must be replaced.
16. Clean Filter Reminder: This message will appear when the filter reminder me has ex-
pired. Remove the filters for cleaning or replacement.
17. Water Refresh Reminder: This message will appear when the “Water Refresh” mer has
expired. The water needs to be drained and refilled with fresh water.

Related product manuals