53
PROBLEM PROCEDURE
POOR JET ACTION 1. Make certain the jets pump is turned on.
2. Check posion of massage selectors.
3. Open air control for selected jet system
4. Check for adequate water level.
5. Check for dirty filter.
WATER IS TOO HOT 1. Reduce thermostat seng.
2. Switch swim spa to “Econo” mode to turn heater on only during
pre-programmed me.
3. Make sure the pumps are turned off an not constantly running.
NO HEAT 1. Check thermostat seng.
2. Keep the cover in place while heang.
3. If the heater indicator is displayed, but no temperature increase
is experienced aer a reasonable period of me, contact your
dealer or authorized service organizaon.
FILTER / CIRCULATION 1. Verify filter / circulaon pump is programmed to run 8 hours
PUMP OFF a day.
2. Make sure there are no errors prevenng the pump from
turning on.
3. Swim spa water is warmer than 95
o
F (34
o
C) and two degrees
warmer than the set temperature.
Jacuzzi builds the best swim spas in the industry. Nonetheless, we are always striving to im-
prove the quality and features of our products. Your input as a Jacuzzi swim spa owner is a
cherished part of this process. If you have any comments or suggesons, or wish to be in-
formed on any new products for your swim spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest and most relaxed family
in the world!
To Next Page
Loading...
Need help?
General