6
In case of long periods of inacvity, it is advisable to fully drain the system. Periodic drainage,
during normal use, varies depending on the frequency of use, the contaminants and the type
of installaon. Even if not used parcularly frequently, you should change the water at least
once a month.
Prolonged sun exposure could damage the material of which the swim spa shell is made,
due to its capacity to absorb heat (dark colours in parcular). Do not leave the swim spa
exposed to the sun without adequate protecon when not in use (thermal cover, gaze
bo, etc.). Any damage resulng from failure to observe these warnings are not covered
by the product warranty.
Live components and equipment (except those powered at very low voltage not exceed-
ing 12V) must be out of reach of individuals in the swim spa.
Jacuzzi® swim spas are class “1” appliances and must therefore be permanently connected,
without intermediate juncons, to the electrical network and to the protecon circuit
(grounding system).
Parts containing electrical components, with the excepon of remote control devices,
must be posioned or fixed so that they cannot fall into the swim spa.
The appliance must be powered by means of a differenal switch with operang current
which does not exceed 30mA.
The installer must use cables with a suitable cross-secon with minimum characteriscs
equivalent to type H 05 VV-F. Please refer to the corresponding secon.
For the equipotenal connecon of the appliance the installer must use the terminal provid-
ed and idenfied by the ground symbol. Please refer to the corresponding secon. It is imper-
ave to build a support base adequate to the load of the swim spa.
It is imperave to provide a drainage system for accidental water spills. Please refer to the
corresponding secon.
To Next Page
Loading...
Need help?
General