Janfire NH - Safety Instructions; General Information

Janfire NH Burner Service Installation Manual 4.16.09 - Technical specifications are subject to change without prior
notice.
3(38)
1 Safety Instructions
1.1 General Information
Read the safety instructions carefully before installation. Always follow the safety instructions during installation and
during maintenance. Follow the safety instructions on the warning signs!
Installation, operation, service and any other work should be carried out by certified and trained personnel and in
accordance to local standards and regulations.
When unpacking, the burner should be checked for any damage. If any parts are damaged contact the installing
contractor.
The local chimney sweep must be informed, an examination of the existing chimney must be performed per NFPA
guidelines and a local building application may be necessary depending on local code requirements.
Before using the system, it must be controlled and fine-tuned. Adjustments and readings are made during start up.
These observations should be written into the installation protocol section of this manual.
NOTE: Always follow these instructions for installation, operation and service.
NOTE: For personal and operational safety: Use only spare parts, which have been manufactured or approved by
Janfire AB.
1.2 Conventions
These safety instructions use the following protocols:
 DANGER!
The text “DANGER!” is used when there is a risk for personal injury or death.
 WARNING!
The text WARNING! is used when there is a risk for damaging the product, unit or control box etc.
 CAUTION!
The text CAUTION! is used when there is a risk for a system failure, operational stop, or disturbances etc.
The warning texts are in hierarchical order. The text “DANGER!” also includes the possibility of the events
covered by “WARNING!” or “CAUTION!”