8200 Compressor
al-CRYOGENICS
HELIX TECHNOLOGY CORPORATION
Table of Contents
Section 1- Introduction
General
1-1
Installation, Operation and Servicing Instructions
1-1
Section 2 - Inspection
Packaging of the System
2-1
The Compressor
2-1
Section 3 - Installation
Compressor Installation
3-1
Preparing the Compressor Input-Power Cable
3-1
Cooling Water Requirements (Water-Cooled Compressors Only)
3-3
Cooling Water: General Considerations
3-4
Cooling Water: Flow and Pressure Requirements
3-4
Cooling Water: Temperature Rise
3-6
Final Preparation
-
of Compressor
3-7
Connecting the Compressor to the Cold Head
3-7
Section 4 - Maintenance Procedures
Scheduled Maintenance
4-1
Removing the Compressor Adsorber
4-1
Installing the Compressor Adsorber
4-3
Unscheduled Maintenance
4-3
Suggested Unscheduled Maintenance Equipment
4-3
Adding Helium Gas
4-4
Helium Circuit Decontamination
4-5
Appendix A - Customer Support Centers
Appendix B - Troubleshooting Procedures
Appendix C - Electrical Schematics for 8200 Compressor
Appendix D - Components in the Electrical Control Module of the
8200 Compressor
•
101111111
■
11111MIN111
■
11111
P/N 8040353
ul
To Next Page
Loading...
