Need help?Do you have a question about the Janis CCS-150 and is the answer not in the manual?
Summary of all safety pressure reliefs and electrical/gas hazards.
Overview of Janis closed cycle refrigerator (CCR) systems and G-M cycle.
Lists major components of Janis CCR systems (Compressor, Cold Head, etc.).
Details various Janis CCR models and their configurations.
Describes how to mount the Janis CCR cold head and compressor assembly.
Specifies voltage and frequency settings for the compressor and controller.
Details air or water cooling needs for the Model 8200 compressor.
Instructions for connecting gas lines, cold head power, and temperature controller.
Step-by-step guide to removing the vacuum shroud and radiation shield.
Procedures for mounting samples, including thermal contact and wiring.
Steps for evacuating the insulating vacuum jacket prior to cooldown.
Procedures for initiating and monitoring the cryostat cooldown process.
Guidance on setting up and using the automatic temperature controller.
Methods for warming the cold head to room temperature to change samples.
Instructions for safely shutting down the compressor and temperature controller.
States no scheduled maintenance for cold head/shroud, but adsorber replacement.
Discusses potential issues like vacuum leaks, wiring failure, or component failure.
Identifies symptoms and actions for vacuum leaks.
Addresses broken wires during sample changes and heater burnout.
Guides users to refer to CTI manual for troubleshooting compressor/refrigerator failures.
Details pin assignments for the 10-pin feedthrough.
Engineering drawing of the Janis CCR system components and dimensions.
Test sheet with operational data and temperature control settings.
Title page of the CTI-Cryogenics manual referenced by the Janis manual.
General| Brand | Janis |
|---|---|
| Model | CCS-150 |
| Category | Refrigerator |
| Language | English |
To Next Page
