janitza JPC 100-PRO - Safety; Warning notices and safety information; Hazard levels; Product safety

www.janitza.com JPC 100-PRO
7
2. Safety
The chapter on Safety contains information
which must be observed to ensure your per-
sonal safety and avoid material damage.
2. 1 Display of warning notices and
safety information
The warning notices shown below
• are found throughout all of the documen-
tation,
• can be found on the devices themselves.
• indicate potential risks and hazards,
• underscore aspects of the information
provided that clarifies or simplifies proce-
dures.
The additional symbol onthedevice itself
indicates anelectrical danger that can result
in serious injuries or death.
This general warning symbol draws atten-
tion to a possible risk of injury. Be certain to
observe all of the information listed under this
symbol in order to avoid possible injury or
even death.
2. 2 Hazard levels
Warning and safety information is marked by
a warning symbol, and the hazard levels are
shown as follows, depending on the degree
of hazard:
DANGER
Warns of an imminent danger which, if not
avoided, results in serious or fatal injury.
WARNING
Warns of a potentially hazardous situation
which, if not avoided, could result in serious
injury or death.
CAUTION
Warns of an immediately hazardous situation
which, if not avoided, can result in minor or
moderate injury.
ATTENTION
Warns of an immediately hazardous situation
which, if not avoided, can result in material or
environmental damage.
INFORMATION
Indicates procedures in which there is no haz-
ard of personal injury or material damage.
2. 3 Product safety
The device reflects current engineering
practice and accepted safety standards, but
hazards can arise nonetheless.
Observe the safety regulations and warning
notices. If notices are disregarded, this can
lead to personal injury and/or damage to the
product.