HEIGHT AND ALIGNMENT OF CLOTH PRESSER BAR 4b
1. Remove: Mains lead.
2. Lower lever "a" and open lamp cover.
3. Loosen screws "b" to remove bracket with lamp holder.
4. Make sure that the shank holder of presser foot is in its highest position.
5. Turn handwheel towards you and bring feed dog below needle plate.
6. Loosen screw "c".
7. With lever "a" in its lowered position, push cloth presser bar down from the top so
that the presser foot touches gauge.(No.11951)
8. Align the needle opening(s) of the presser foot with those of the needle plate, and
fasten screw "c".
9. Refit bracket with lamp holder.
18
To Next Page
