Janome 1200D - Position of Program Selection-Display Drum Indicator and Display Window; Lever and Tension Cam Alignment; Drum Indicator and Display Window Alignment

E
1. Remove: Mains lead - Front cover.
2. Select sewing program 1 "SAFETY 4THREAD"
3. Check and make sure that the lever "h" is facing the notch of tension cam "g" for
yellow needle thread.
4. If not loosen screw "a" and turn DT cam pulley "j" forward or backward until the
lever "h" is facing the notch of tension cam "g". Then, tighten screw "a".
5. If the position of the display drum indicator "d" is not aligned with the display
window "e", then loosen screw "c" and adjust the position of drum.
6. Fasten screw "c" and recheck the position of the display drum "d".
Note: In order to check the alignment of the display drum indicator "d" and the disolay
window "e", it is necessary to set the front cover on to machine.
POSITION OF PROGRAM SELECTION-DISPLAY DRUM INDICATOR
AND DISPLAY WINDOW
g
a
c
h
d
e
SELECT
h
g
b
d
2 mm
j
7