Janome 13512 - Feed Balance on Stretch Stitch

19
(D)(C)
Stretch stitch
adjusting screw
A=B A>B A<B
Cap
Notch
A
A
1
2
3 B
A
A
1
2
3 B
A
A
1
2
3 B
MECHANICAL ADJUSTMENT
FEED BALANCE ON STRETCH STITCH
TO CHECK:
If the stretch stitch patterns are distorted with setting the stitch length dial at " S.S. ".
(In case of being a difference between forward feeding and backward feeding during stretch stitch pattern
sewing), make an adjustment as follows:
ADJUSTMENT PROCEDURE:
1. Remove the cap.
2. Set the pattern selector dial at " " , and the stitch length dial at "S.S.".
3. Turn the stretch stitch adjusting screw in the direction of (C) when A > B, or in the direction of (D) when A < B.
4. Attach the cap.