20
Adjusting screw
(D)
(C)
Backward feeding
Forward feeding
Stitch length dial
MECHANICAL ADJUSTMENT
BARTACK FEED OF BUTTONHOLE
TO CHECK:
If the material is fed forward or backward when sewing bartack on buttonhole, make an adjustment as follows:
ADJUSTMENT PROCEDURE:
1. Set the pattern selector dial at " ", and the stitch length dial at "4".
2. Remove the front cover (See page 6).
3. Place a piece of paper under the foot and turn the handwheel.
If the paper is fed forward, turn the adjusting screw in the direction of (C).
If the paper is fed backward, turn the adjusting screw in the direction of (D).
4. Attach the front cover.
To Next Page
Loading...
