30
Before you start sewing your garment, try test
stitching with the same thread and fabric as your
garment.
z Tu rn the stitch length adjustment dial q to
adjust the stitch length.
Slide the needle and bobbin threads to the back
under the presser foot. Use the same fabric for
actual sewing.
x Tu rn the handwheel w toward you to lower the
needle into the fabric.
c Set the speed control slider to (slow) until
you get used to the sewing speed.
Lower the presser foot lifter e.
Press the foot control r to start sewing.
z
x
c
v
b
NOTE:
Raise the thread take-up lever to its highest
position, otherwise the needle thread may slip
out from the needle eye.
Test Stitching
w
e
r
t
y
u
q
HOW TO SEW
v Check the sewing result and adjust the needle
thread tension t as necessary.
b Press the auto thread cutter button y to trim
the threads.
You can continue sewing without pulling the
bobbin thread up to the needle plate after
trimming the threads.
* Use the thread cutter u on the face cover if the
thread is thicker than #30.
Palanca tira hilos
Bras de relevage
du fil
Thread take-up
lever
NOTE:
The machine will not run if the presser foot is in
up position.
To Next Page
Loading...
