Janome 2000CPX - THREADING THE LOOPER; Threading the Looper

24
q
(A)
(B)
z
Threading the looper
Thread the looper in the following steps:
z
Draw the thread through the right side thread guide
bar from back to front as shown (A).
NOTE:
If the thread is coming out from the thread guide notch,
pass the thread through the thread guide hole again as
shown (B).
q
Thread guide bar
1
2
3
4
5
6
7
8
w
x
x
Slip the thread into the thread guide plate on the
machine as shown.
w
Thread guide plate