Janome 625E - Winding the Bobbin

16
MODEL 625E
Adjusting Buttonhole Zero Feed
• If the fabric is fed when sewing a bartack of the buttonhole, correct it
as follows:
<To adjust>
Sew a test buttonhole to check if the fabric is fed while sewing the bartacks.
Remove the cap to access the adjusting screw.
If the fabric is fed foward (A), turn the adjusting screw in the direction (C).
If the fabric is fed backward (B), turn the adjusting screw in the direction (D).
Attach the cap.
Bartack
Bartack
Cap
Adjusting screw
Adjusting screw
(B)
(A)
Stitch length dial
(D)
(C)