Janome 625E - Replacing Motor and Adjusting Motor Belt Tension

18
MODEL 625E
Motor connector
Circuit board B case
Replacing Motor and Adjusting Motor Belt Tension
<To replace the motor>
Remove the face plate, base cover, front cover and rear cover (see pages 1 to 4).
Remove the case, disconnect the motor connector. (see page 20).
Remove the setscrews (C) and motor.
To attach the motor, follow the above procedure in reverse.
<To adjust the motor belt tension>
Slightly loosen the setscrews (C).
While pushing the middle of the motor belt with a 300 grams load, move the motor up or down so
that the belt deflects 7 to 9 mm.
Tighten the setscrews (C) securely.
Setscrew (C)
Motor
7 to 9 mm
300 grams load