Janome DC2010 - Inserting the Bobbin

22
Inserting the bobbin
z Place the bobbin in the bobbin holder with the
thread running counter-clockwise.
q End of the thread
w Bobbin holder
q
w
e
t
r
t
y
u
z
x
c
v
b
b Pull out about 10 cm (4") of thread and attach the
hook cover.
y Bobbin thread
u Align left edge of the hook cover.
v Draw the thread to the back.
The bobbin should turn counterclockwise when
pulling the thread.
c Continue to draw the thread lightly through the
tension blades until it slips into slot B.
r Tension blades
t Slot B
x Guide the thread into slot A on the front side of the
bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
e Slot A