42
Using Built-in Monogramming Mode
z Turn on the power switch:
When the built-in monogramming mode key is
selected, the carriage will move.
* Make sure nothing is blocking it.
* Before turning off the power switch and covering the
machine, be sure to return to the first menu. This
will return the carriage to its home position.
* Avoid turning the handwheel by hand while the
carriage is moving.
q
Carriage
x A setting reminder message is displayed for three
seconds. Suitable thread tension level is indicated.
Adjust the top thread tension by turning the
thread tension dial, if necessary. Make sure that the
feed dog is in lowered position.
Attach the embroidery foot P.
w
Thread tension dial
w
q
e
c Alphabet (block style or script style) can be
selected.
The clothsetter key is for using the
clothsetter (optional).
Press the menu key to return to the menu screen.
e
Clothsetter Key :
r
Raised position
t
Lowered position
z
x
c
zx
r
t
¡ To Attach Embroidery Foot P
z Raise the presser foot lifter, loosen the screw and
remove the foot holder .
Attach Embroidery Foot P and securely tighten the
screw with the screwdriver.
x Set the pressure dial at “2”.
Note: After the completion of sewing, return the
dial position “3”.
3
2
1
1
3
2
Clothsetter Key
To Next Page
Loading...
