FOR YOUR SAFETY
A person entering the machine’s operation area may be injured.
Put up a “No Entry” or “No Operating” warning sign in a clearly visible
position near the machine.
Do not sprinkle water or oil on the unit, control box, or its cable.
Contact with water can cause electric shock, fire, or malfunction of the unit.
IP Protection Rating is IP40.
Power the unit only with the rated voltage.
Excessive voltage can cause fire or malfunction of the unit.
Check the mounting screws regularly so that they are always firmly
tightened.
Loose screws may cause injury or damage.
Regularly replace the built-in battery (optional) in the body or control
box. It is preferable to replace it every 3 years.
Failure to do so may cause malfunction or defect.
Keep the emergency stop switch within reach of an operator while
teaching and running the machine.
Failure to do so is dangerous because the machine cannot be stopped
quickly and safely.
Regularly check that the I/O-S circuits and emergency stop switch work
properly.
Failure to do so is dangerous because the machine cannot be stopped
quickly and safely.
Do not leave the unit plugged in (power cord and connectors) when it
is not in use for long periods of time. Dust can cause fire.
Be sure to shut off the power supply before removing the power cord.
Warnings
Setup Electro Press JP Series 4 ii
To Next Page
Loading...
