Be sure to attach this sticker in plain view.
1.2 Notices regarding installation
・ Place the machine on a suitable flat surface that can support its
weight. Be sure to leave a space greater than 30cm between the back
of the control box equipped with a cooling fan and the wall. Do not
cover the cooling fan vent on the top of a stand-alone or head type press.
An insufficient or unstable area can cause the machine to fall, overturn,
breakdown, or overheat.
・ Do not use the machine near inflammable or corrosive gas. If
leaked gas accumulates around the machine, it can cause fire or
explosion.
・ Place the machine in a well-ventilated area for the health and safety
of the operator.
・ Use the machine in an environment that is not dusty or damp.
・ Use the machine in an environment between 0 to 40 degrees
centigrade with humidity of 20 to 95 percent without condensation.
Use outside these conditions may result in malfunction.
IP Protection Rating is “IP40.”
・ Avoid using any equipment emitting electric noise nearby. Electric
noise can cause the machine to break down.
For Your Safety Electro Press JP Series 4 3
To Next Page
Loading...
