・ Do not disassemble or modify the machine. This can cause electric
shock or malfunction of the machine.
・ Place the control box on a flat surface more than 80 cm above the floor so
that it is easier to operate.
・ Place the machine at a height suitable for the operator.
・ The installation mount should be steel. For the stand-alone type, it
should be able to support the machine’s weight. For the head and
unit types, it is able to support the machine’s weight and pressing
capacity.
・ Make sure the jig is firmly attached. A loose jig may result in injury or
breakdown of the machine.
・ Install the emergency stop switch within reach of the operator while
teaching and running the machine. Failure to do so may cause
danger because the machine cannot be stopped immediately and safely.
For Your Safety Electro Press JP Series 4 5
To Next Page
Loading...
