FOR YOUR SAFETY
Do not drop or jar the unit during transport and/or installation.
This causes injuries or damages the unit.
Before performing any operation, ensure there is no imminent danger to any of
the operators. Failure to do so causes injury.
Use the unit in an environment between 0 and 40°C, with a humidity level of 20 –
90%, and without condensation.
Use outside of these conditions can cause unit malfunction.
Use the unit in an environment where no electrical noise is present.
Failure to do so causes unit malfunction or breakdown.
For models with I/O-S circuits, when installing the unit, take safety measures
such as setting up area sensors and an enclosure.
If there are no
safety measures in place and someone enters the area of operation
when the robot is running, they may be injured.
Keep the emergency stop switch within reach of the operator when running or
operating the robot.
If the robot is operated when the emergency switch is not within reach, it may not be
possible to stop the robot immediately and safely. This is potentially dangerous.
Make sure that you regularly perform a function check of
switch(s). Also, for models with I/O-S circuits, regularly perform an I/O-S circuit
function check.
If the robot is operated without making these checks, it may not be possible to stop the
robot immediately and safely in an emergency. This is potentially dangerous.
Caution
12
To Next Page
Loading...
Need help?
General
