Janome JR3300 series - User Manual

JANOME DESKTOP ROBOT
JR3000 Series
Operation Manual
External Control
(I/O / Fieldbus)
Thank you for purchasing this Janome Robot.
•
Before using your robot, read this manual thoroughly and always make
sure you use the robot correctly. In particular, be sure to thoroughly read
“For Your Safety” as it contains important safety information.
•
After reading this manual, store in a safe place that can be easily
accessed at any time by the operator.
Original Instructions

Summary

Preface and Safety Information

Introduction and Manual Scope

Introduces the manual, lists related manuals, and outlines its scope.

General Safety Precautions

Provides critical safety warnings and precautions for robot operation and installation.

I;O System Basics and Functions

I;O-SYS Interface Details

Covers I/O-SYS connectors, polarity, wiring, power, and signal diagrams.

System Input;Output Functions

Describes the purpose and behavior of system input and output signals.

I;O-1 Interface Details

Details I/O-1 connector, pins, functions, power, and signal diagrams.

I;O-MT Interface Details

Explains I/O-MT connector, pins, functions, power, and signal diagrams.

Fieldbus Communication and Operation

Fieldbus Overview and Settings

Introduces Fieldbus types, safety, and general setup procedures.

Protocol Specific Configurations

Details settings for DeviceNet, PROFIBUS, CC-Link, CANopen, PROFINET, EtherNet/IP.

Fieldbus Expansion I;O Functionality

Explains using Fieldbus for advanced I/O functions and data exchange.

Signal Timing and Advanced Configurations

Signal Timing Charts

Illustrates operational sequences and signal interactions under various conditions.

I;O-S Interface Details

Explains I/O-S connector, safety device connection, and safety circuit.

Janome JR3300 series Specifications

General

Stitch Width	0-5 mm
Stitch Length	0-4 mm
Foot Pedal	Yes
Weight	20 lbs
Bobbin	Top drop-in