47
CARE AND MAINTENANCE
Cleaning the Hook Race
WARNING:
Turn the power switch off and unplug the machine
before cleaning.
NOTE:
Do not dismantle the machine in any way other than
what is explained in this section.
Clean the outside of the machine with a soft cloth and
mild soap.
z Remove the setscrews with the screwdriver
supplied with the machine. Remove the needle
plate.
x Lift up the bobbin holder and remove it.
q Screwdriver
w Setscrews
e Needle plate
c Clean the bobbin holder with a lint brush.
r Bobbin holder
t Lint brush
v Clean the Auto thread cutter mechanism and hook
race with the lint brush.
y Auto thread cutter mechanism
u Hook race
b Clean the hook race with a dry cloth.
(You may also use a vacuum cleaner.)
i Dry cloth
Assemble the hook race
n Insert the bobbin holder so that the knob fits next to
the stopper in the hook race.
o Knob
!0 Stopper
m Reattach the needle plate, aligning the needle plate
guide pins with the guide holes on the needle plate
and tighten the screw.
!1 Needle plate guide pins
NOTE:
After cleaning the machine, make sure the needle and
presser foot are attached.
z
x
c
v
b
n
m
q
w
e
r
r
t
y
i
u
!0
o
!1
!1
To Next Page
Loading...
