58
u Hoop calibration
You can calibrate the center position of the hoops.
Press the Yes key.
u-1 Yes key
u
u-2
The carriage moves to the center position.
Press the hoop selection key to open the hoop selection
window.
u-2 Hoop selection key
Select the hoop and attach it to the carriage. Set the
template in the hoop.
Adjust the hoop position by pressing the jog keys so that
the needle is right above the hole in the template.
Press the OK key.
Press the next page key to go to the next menu.
u-1
The caution message appears.
Press the OK key.
y
y
Hoop conrmation
The hoop conrmation message will appear every time
before opening the Ready to Sew window. However you
can turn this option off by selecting off.
To Next Page
Loading...
