63
Direct PC-Link
You can connect the machine to a PC with the USB cable
included in the standard accessories.
You need to install Embroidery Editor and the USB driver
for the machine on your computer.
Embroidery Editor and the USB driver are available in
the Embroidery Editor CD-ROM included in the standard
accessories.
Start up the machine and PC, and insert the type “A”
USB connector into the PC.
Insert the type “B” connector into the machine.
You can send original embroidery design data from a PC
to the machine.
Refer to on-screen help of Embroidery Editor for more
details.
Changing a name of the le or folder
Press the rename key and select the le or folder for
which you wish to change the name.
The keyboard window will open.
Enter a new name and press the OK key.
The name of the le or folder will be changed.
q Rename key
If you enter a name that already exists, the message “The
same name exists.” will appear.
Press the X key and enter another name.
q
CAUTION:
Do not turn the power off or disconnect the USB
cable while the data transfer is in progress, as this
will cause loss of data and can damage the machine’s
memory.
To Next Page
Loading...
