Janome OC 6260 - Inserting the Bobbin

12
•
Inserting the bobbin
Place the bobbin in the bobbin holder with the
thread running counter-clockwise.
End of the thread
Bobbin holder
Guide the thread into the notch A on the front side
of the bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
Notch A
Continue to draw the thread lightly through the
tension blades until it slips into notch B.
Notch B
Draw the thread to the back.
The bobbin should turn counterclockwise when
pulling the thread.
Pull out about 10 cm (4˝) of thread and attach the
hook cover plate.
Bobbin thread
Hook cover plate
Threading chart
Align left edge of the hook cover.
1
2
3
4
3
4
8
5
7 6
1
2
3
4
1
2
3
4
5
6
7
8
1
2