Janome OC 6260 - Stitching Techniques and Applications; Selecting and Adjusting Stitches

16
Selecting the Stitch Pattern
Press the pattern selection key until pattern number of
the desired stitch is shown in the LED display.
The key (1) on the left selects patterns #01 to #15.
The key (2) second from the left selects patterns #16 to
#30.
The third key (3) selects patterns #31 to #45.
The last key (4) selects patterns #46 to #60.
NOTE: Raise the needle above the fabric when selecting
the stitch pattern.
Adjusting the Stitch Width
Press the plus (+) or minus (–) key on the left to change
the stitch width.
The LED display will show the default value of the
selected pattern when you press the plus or minus key
once.
Adjusting the Stitch Length
Press the plus (+) or minus (–) key on the right to change
the stitch length.
The LED display will show the default value of the
selected pattern when you press the plus or minus key
once.
#
01 16 31 46
Sensor
(1) (2) (3) (4)