Why is my Janome noisy and not running smoothly?
If your Janome Sewing Machine does not run smoothly and is noisy, it could be because thread has been caught in the hook race, so remove the caught thread. Another possibility is that lint has built up in the hook race or bobbin holder, so clean the hook race or bobbin holder.
What to do if my Janome is skipping stitches?
If your Janome Sewing Machine is skipping stitches, there are a few potential reasons. Make sure the needle is inserted correctly. A bent or blunt needle can also cause this issue, so replace it if necessary. Ensure that the needle and threads you're using are suitable for the fabric. If you're sewing stretch, very fine fabrics, or synthetics, try using a blue tip needle. Finally, double-check that the needle thread is threaded properly.
What to do if the cloth is not feeding smoothly in my Janome ?
If the cloth isn't feeding smoothly, check the following: * The feed dog might be packed with lint. * The presser foot pressure might be too weak. * The stitches might be too fine; if so, make the stitches coarser. * The feed dog might not be raised after “Drop feed” has been used.
Why is my Janome Sewing Machine running noisy and not smoothly?
Your Janome sewing machine may not run smoothly and could be noisy if: * Threads have been caught in the hook mechanism. * The feed dog is packed with lint.
What causes skipped stitches on my Janome ?
Skipped stitches can occur if: * The needle is not inserted properly. * The needle is bent or blunt. * The needle thread is not threaded properly. * The fabric is not stretched tight enough in the hoop.
Why aren't the buttonhole stitches balanced on my Janome ?
General| Brand | Janome |
|---|---|
| Model | Sewing Machine |
| Category | Sewing Machine |
| Language | English |
To Next Page