What to do if the performance at wavelengths shorter than 320 nm is not stabilized in Jasco V-570 Measuring Instruments?
If the performance at wavelengths shorter than 320 nm is not stabilized in Jasco Measuring Instruments, set the D lamp to “On”.
What to do if the baseline is curved greatly in excess of 1% in Jasco V-570 Measuring Instruments?
If the baseline is curved greatly in excess of 1% in Jasco Measuring Instruments, check if baseline correction is set to “Off”. If it is, set it to “On”.
What to do if the performance at wavelengths longer than 400 nm is not stabilized in Jasco Measuring Instruments?
If the performance at wavelengths longer than 400 nm is not stabilized in Jasco Measuring Instruments, set the WI lamp to “On”.
General| Photometric Range | -4 to 4 Abs |
|---|---|
| Resolution | 0.1 nm |
| Scan Speed | Up to 4000 nm/min |
| Spectral Bandwidth | 0.5, 1, 2, 5 nm |
| Light Source | Deuterium |
| Wavelength Repeatability | ±0.1 nm |
Explains signal words, symbols, and warning labels for safe operation.
Details warning labels for fuses, grounding, and instrument carrying.
Describes manual layout, notation, and software startup.
Covers navigation of Spectra Manager menus and program exiting.
Details quantitative analysis, calibration curves, and sample measurement.
Explains spectrum measurement, parameter setting, and baseline.
Covers time course and fixed wavelength measurement modes.
Describes the Abs/%T meter display and its controls.
Covers hardware settings, diagnosis, and accessories configuration.
Step-by-step guide for installing Spectra Manager software.
How to set the serial port for spectrophotometer control.
To Next Page
