12
Picture 1-3 Welding operation selecting zone
Gas indicator and selection button are included.
Operation methods including spot, 2T and 4T can
be selected by pressing the button. Corresponding
indicator will be on according to selected operation
method.
Note: This function is unavailable for lift TIG
and MMA.
Picture 1-4 Welding wire diameter selecting
zone
Welding wire indicator and selection button are
included.
Welding wires including solidΦ0.8、Φ1.0、Φ1.2 and
SP can be selected by pressing the selection
button. Corresponding indicator will be on
according to selected welding wire.
Note: This function is unavailable for lift TIG
and MMA.
Picture 1-5 Welding procedure parameters selecting zone
Parts such as procedure parameters indicator, right cycle selection button, etc are included.
Procedure parameters including preset parameter (pre-flow time), initial parameters (speed, current and
voltage), upslope parameter (time), downslope parameter (time), arc stopping parameters (current,
speed and voltage) and post-set parameter (post-flow time) can be selected by pressing right selection
button. Corresponding indicator will be on according to selected parameters. Welding indicator will be on
at the beginning of welding and off at the end of welding for instruction.
To Next Page
Loading...
