Operating instructions DPK 6207…
© BA_DPK_EN_Rev06-2010.docx Page 17 of 18
12 DECLARATION OF INCORPORATION
within the meaning of EU Directive 2006/42/EC, Annex II Part 1.B
Manufacturer, address JAUDT Dosiertechnik
Maschinenfabrik GmbH
Raiffeisenstr. 3 - 5
86167 Augsburg
Tel. ++49 (0)821 79605-0
Documentation officer Wolfgang Morell, JAUDT Dosiertechnik GmbH
Product denomination / Device Type douple shuttle valve / 6207…
The above partly completed machinery is governed by the requirements of Directive 2006/42/EC
Annex I, its general principles and its Part 1 and where appropriate Point 2.1. If used in areas at
risk of explosion Directive 94/9/EC (ATEX) also applies.
The fundamental requirements 1.3.3 and 1.3.4 can be ensured. The above requirements can only
be ensured through proper installation.
In addition, the above product conforms in the supplied version to the provisions of Directive
2006/95/EC “Low Voltage Directive” and 2004/108/EC “Electromagnetic Compatibility”.
For the purposes of assessment of conformity the manufacturer produced the special technical
documentation pursuant to Directive 2006/42/EC Annex VII Part B. This documentation will be sent
to the authorities of the individual member states in file form on justified request.
The above partly completed machinery is intended solely for incorporation in another machine.
Commissioning is prohibited until it has been ascertained that the machine / system into which the
partly completed machinery is to be incorporated meets the requirements of all the above
directives.
JAUDT Dosiertechnik GmbH
Raiffeisenstraße 3-5 Robert Roßkopf
D-86167 Augsburg Managing Director
Augsburg, 30.03.2010
To Next Page
Loading...
Need help?
General
