EasyManua.ls Logo

Jayco 2016 PINNACLE - Page 109

Jayco 2016 PINNACLE
167 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
99
plumbing SyStem
If you smell propane gas then STOP! and follow the procedures listed in the
Fuel Systems section of this manual before attempting to operate the water
heater.

Operating instructions:
Read the safety and operating information provided in the manufacturers manual before
attempting to activate the water heater.
Make sure the water heater is lled with water before use; even momentary operation of
the water heater without water in it may result in damage to the tank heating element and/or
controls. Double check the bypass valves, make sure they are set properly.
Always open both the hot and cold water faucets when lling the fresh water tank to allow
air pockets to be forced out of the water heater
Water heater switch (if so equipped)
The “propane GAS” water heater switch enables propane operation of the water heater. The
“ELECTRIC” water heater switch enables electric operation of the water heater
Water heater-pilot light (if so equipped)
This water heater is gas only with a pilot ignition. The water heater controls are typically
located in an outside compartment, and is ignited manually from the outside of the vehicle.
Hot water will be available in approximately 30 minutes.
Refer to the water heater manufacturers manual for lighting instructions.
Water heater bypass (If So Equipped)
Your recreation vehicle may be equipped with a water heater bypass. This three-valve
system is located at either the water heater, or on the system panel depending on your model.
For detailed information see the Water Heater Bypass section
Water heater switches (if so equipped):
Switches are located on the Monitor Panel. For detailed information on their operation refer
to the Monitor Panel section.
Water Heater pilot ignition

Table of Contents

Related product manuals