106
plumbing SyStem
5. Put the sanitizer solution in the fresh water tank:
Attach a hose to the City Water Connection inlet. Insert the other end of the hose
into a container holding the chlorine solution. Do not use your non-toxic drinking
water hose. Turn the pump switch ON. Solution will be drawn into the fresh water
tank. Turn pump OFF when solution has been drawn into the tank. (NOTE: to aid in
siphoning, set the container on a surface approximately 2 feet off the ground) Drain
valves must be turned OFF.
6. Remove the chlorine container and nish lling the fresh water tank with clean
(potable) water until tank is full:
Keep the valves set on SANITIZE. Leave the hose attached to the City Water
Connection inlet, place other end of hose in a container of fresh water. Turn pump
ON. Fresh water will be siphoned into the tank. Turn pump OFF when tank is full.
Disconnect the hose from Utility Center.
7. After the recommended amount of sanitizing solution is in the tank, the water tank is
full, and cartridge water lter (if so equipped) bypassed or the lter is removed from the
full system canister water lter (if so equipped). Power to water heater should be OFF.
(both switches: Electric & LP GAS) When the fresh water tank is full:
Set valves to the DRY CAMPING setting. Turn the pump ON and sanitized water will
ow into the water lines from the tank.
8. Open all hot water faucets one by one until water begins to ow continuously and a
chlorine smell is noticeable. Include outside shower faucets (if so equipped). Close hot
water faucets.
9. Open all cold water faucets one by one until water begins to ow continuously and
you smell chlorine. Include outside shower faucets (if so equipped). Close cold water
faucets.
10. Turn OFF the water pump.
11. Let the solution remain in the tank & lines for at least four hours when disinfecting with
50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM chlorine
concentration should be permitted to sit in the system for at least one hour.
12. After the required period, drain the chlorine solution from the fresh water system (see
Draining the Fresh Water System).
NOTE: To thoroughly sanitize the fresh water tank, the unit should
be driven around for a period of time allowing the solution to splash
the sides and top of the tank
To Next Page
Loading...
