37
6. Repeat steps 2 through 5 if needed.
7. Turn power o to the leveling system by pressing the power button.
8. Visually inspect all jacks to ensure all shoes are touching the ground. If one of the rear
jack shoes not touch the ground, press the corresponding LEFT or RIGHT button to
lower the non-compliant jack to the ground.
1. Press the power button to energize the system. LCD screen will display JACKS
DOWN.
2. Press DOWN ARROW to display AUTO RETRACT on the screen.
3. Press ENTER to begin automatically retracting the jacks.
Manual Leveling Procedure
4. When the JACKS DOWN display goes o, press the power button on the Control Panel
to de-energize the system. After a brief visual inspection around the coach to verify the
jacks are all fully retracted, you may proceed to travel.
5. AUTO RETRACT can also be commenced by pressing and holding the RETRACT
button for 1 second.
In the event the jacks will not extend or retract there is a manual procedure where the jacks
can be overridden with the use of a hex wrench. For specic instructions on the override
procedure refer to the manufacturer’s owner’s manual found in your warranty packet.
If the ignition is in the “RUN” position, jacks are down, and the operator releases the parking
brake, all indicator lights will ash and the alarm will activate. The system will then auto-
matically retract the jacks until the jacks are fully retracted or the operator resets the parking
brake. The power unit will also operate to keep the jacks retracted in the event the leveling
system loses pressure as the coach is being driven.
Failure to act in accordance with the following warning may result in serious
personal injury or death!
WHEELS MUST LEAVE THE GROUND DURING LEVELING
OF THE RV.
To Next Page
Loading...
Need help?
General
