55
1. At either “START/STOP” switch, press and hold the upper portion of the switch to
start the generator. Depending on the outside temperature the start process can take up
to 15 seconds. Once the generator starts running, release the “START/STOP” switch.
2. An LED above the start switch will light when the generator is running.
3. For better performance and engine life, especially in colder weather, let the generator
engine warm up for two minutes before turning “ON” 120-volt appliances.
For more information on generator operation and maintenance, refer to the manufacturer’s
owner’s manual.
Certain models of motorhomes may be equipped with an Automatic Generator Start system
(AGS). The controls are built into the Firey touchscreen system. When enabled, the Auto-
matic Generator Start system will automatically start and stop the generator.
Replacing Light Bulbs
Before replacing a bulb, be sure the light is o.
Replacement light bulbs must be of the type, voltage and wattage listed on the lamp xture.
Use of incorrectly sized bulbs can overload lamp circuits and may create a re hazard by
overheating the xture.
To Next Page
Loading...
Need help?
General
