EasyManuals Logo

Jayco Swift User Manual

Jayco Swift
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image

69
to the water heater, and can be accessed through the opening on top of the (driver side) sofa
base. See Sanitizing/Winterizing the Plumbing System for bypass details.

Excessive pressure from the water supply source may be encountered in some parks, espe-
cially in mountain regions when using the fresh water inlet or black tank ush. Water pres-
sure regulators are available to protect your recreational vehicles plumbing system against
such high pressure.

There must be sucient 12-volt DC power to run the water pump when your recreation
vehicle is not hooked up to city water. Once activated, the water pump (also known as the
demand pump) will self-prime and provide water. The pump is designed for 
. Using the pump continuously or with high pressure will shorten the life of the
pump and is not covered in your warranty.
Periodically check the in-line water pump strainer for ac-
cumulated debris. To clean, shut o the water pump, un-
screw the clear cap, remove the re-useable metal strainer,
clear any debris, then reinstall.
For additional information on the care and operation
of the pump, read the safety and operating information
found in the pump manufacturers owners manual.

Most water pump switches illuminate when the water pump is activated. Typical switch
locations are in the back of the unit or on the monitor panel. When the water pump switch
is ON the pump runs until 45 lbs. of pressure has been achieved. The red light will stay
on. The water pump automatically recycles when pressure drops. Some cycling may occur
depending on the volume of water being released. Turn the water pump switch OFF when
not in use.



A water pressure regulator is recommended to prevent damage to the plumb-
ing system or components. To prevent damage when using the city water
connection, a 45 lb. (315 KPa) rated water pressure regulator is recommended.

Fresh Water Connections
Your recreation vehicle is equipped with a city water ll threaded connector. There is a city
water connection label next to the connection. Do not remove this label.
 If needed, sanitize the water system prior to travel.
Table of Contents
Maintenance Record

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jayco Swift and is the answer not in the manual?

Jayco Swift Specifications

General IconGeneral
Seatbelts4
Fuel TypeDiesel
ShowerYes
ToiletYes
CategoryMotorhomes
Gross Vehicle Mass3500kg
TransmissionAutomatic

Related product manuals