JB.lab ClusterTALK2 - Multipoint

MULTIPOINT
31
MULTIPOINT
CLUSTER TALK2 can connect with 2 devices at once.
1. Connect one of two device which have bluetooth function with CLUSTER
TALK2 (p.26 refer to bluetooth pairing)
2. Turn off CLUSTER TALK2 and connected device.
3. Turn on CLUSTER TALK2 and connect it with the rest device.
4. Connect CLUSTER TALK2 with previously connected device
Remark : Search 2 devices in connection action in case of Multi-point
function has been turned on.
In case of 1 device is found, irregular Streaming can happen. Streaming
is played normally in case of 2 devices are found at that time.
Turn off multipoint function if you want to use only 1 smartphone. And turn
on multipoint function if you want to use only 2 smartphones. (refer to the
Turn on/off the Multipoint)
*While calling, press the button once, previous call is cut off and post
call is received.
Press the button lengthily, previous call is not cut off and post call is
received.
If you want to receive the standby status previous call again, press the
button lengthily again. Or press the button shortly post call is cut off and
previous call is received.
TURN ON/OFF THE MULTIPOINT
The function has been turn off on basically.
1. Turn off the Bluetooth function of smartphone.
2. Press the button 3 seconds to enter to the pairing mode.
(Red/blue LED rapidly alternately flickering)
*Function is decided by time that press button. (Division is possible at
effect sound)
*In multipoint OFF, connection history is removed. So we have to do
pairing again.
KO
EN
FUNCTION
Multipoint ON
Multipoint OFF
OPERATION
Press and hold Button for about 3 second
Press and hold Button for about 5 second