Need help?Do you have a question about the JBL DSP4086 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Number of Channels | 4 |
| DSP | Yes |
| Crossover | Yes |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | <0.05% |
| Signal-to-Noise Ratio | >95dB |
| Crossover Type | High-pass/Low-pass |
| High-Pass Crossover Frequency | 20Hz - 20kHz |
| Low-Pass Crossover Frequency | 20Hz - 20kHz |
| Bass Boost | 0-12dB |
| Dimensions (W x H x D) | 238mm x 52mm x 194mm |
Connects the amplifier to the vehicle's battery and remote turn-on sources.
Describes the function of the green and red LED indicators for power and protection.
Connects preamp outputs from source units using RCA patch cables.
Connects speaker output wires from source units without line-level outputs.
Assign speaker locations and view current assignments in the system.
Adjust individual channel volume, muting, phase, and linking for balanced output.
Monitor clipping indicators, voltage, and amplifier operating temperature.
Configure time delay, crossovers, and input mixing for desired audio.
Control master volume and save/load audio settings as presets.
Provides a link to download the owner's manual in PDF format.
Links to the official JBL store for products and information.
Lists other relevant manuals for JBL products.
To Next Page
