7
CD Player/Tuner Stereo System HARMONY
8. Pause - Press this button on the Harmony or remote
to cause the CD to pause.
9. Play - Press this button on the Harmony or remote to
cause the CD to begin playing.
10. Stop - Pressing this button will stop the CD playing.
11. Volume - To raise the volume turn the knob on the
Harmony clockwise or push “+” on the remote. To lower
the volume turn the knob counterclockwise or push “-” on
the remote.
12. Open - This button will open the CD holder tray
ejecting the CD.
13. IR Receiver - This is the area where the Infrared
Remote Receiver is located.
14. Auxiliary - Press this button to activate the auxiliary
audio input. This allows for the hookup of a cassette
deck, hi-fi VCR, CD changer, computer or another audio
source.
15. Power Indicator - This light indicates that the
Harmony is on when lit. To turn the Harmony on push
either “AUX”, “AM/FM”, “CD”, “PLAY” or “ALARM OFF” on
the Harmony or remote (or on the Harmony or
“Standby” on the remote).
16. AM/FM - This button allows the switching between
the AM and FM selection of the tuner.
17. CD Selector - Press this button on the Harmony or
remote to change to CD playing mode.
18. CD Door - this door opens allowing the CD tray to
slid out.
19. Store - Tune to the station that you wish to place in
memory. Push “Store” on the Harmony. To skip
between preset stations push or .
20. Display - Push this button to turn off the CD time
display or tuner display. When Harmony is off, pushing
this button will light up the clock display for five seconds.
21. Random Play - Push this button to play the tracks of
a CD in random order. The Harmony will automatically
delete each track it has played.
22. Repeat - Push Repeat to repeat the entire CD
playing. Push Repeat again to repeat a single track only.
The “Repeat” indicator will flash. Note: If “Random” and
“Repeat” are both engaged, the CD player will randomly
play the disc, deleting all played tracks, until the disc is
finished. It will then randomly play the disc again.
23. Mono - Pressing this button will play the selected
station without any stereo separation. There will be
much less background noise.
24. Sleep - This Button is used to turn the unit off
automatically after a selected amount of time in 10
minute increments up to 90 minutes. To turn off sleep
mode, push “Sleep” until “00” is indicated in the display.
25. Standby - Pressing this button on the remote will
cause the Harmony to turn on.
26. Mute - Press this button to lower volume completely
on the remote control, causing the power indicator to
flash. When “Mute” is pushed again, the volume will
return to its original level.
M
Mono
AM/FM
CD
Aux
12
StandbyStandby
AlarmAlarm Random
Random Repeat
Repeat
SnoozeSnooze
SleepSleep
VolumeVolume
20
23
24
25
21
22
17
16
14
1
5
6
7
8
9
11
26
10
To Next Page
Loading...
Need help?
General
