JBL SUB10 Owner's Guide

7
SPECIFICATIONS
SUB10
Frequency Response 27Hz – 150Hz
Amplifier RMS Power 150 Watts
Amplifier Peak Dynamic Power
†
300 Watts
Crossover Frequencies 50Hz – 150Hz,
24dB/octave, continuously variable
Driver 10" (250mm) PolyPlas
™
Dimensions (H x W x D) 17-3/4" x 12-1/4" x 15-3/4"
(with grille) (451mm x 311mm x 400mm)
Weight 32.1 lb (14.6kg)
†
The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured
across the output of a resistive load equal to minimum impedance of the transducer, using a 50Hz
sine wave burst, 3 cycles on, 17 cycles off.
Venue Sub10 (120V) OM 2/3/06 11:39 AM Page 9

JBL SUB10 Specifications

General

Type	Powered Subwoofer
Enclosure Type	Bass Reflex
Woofer Size	10 inches
Inputs	Line-Level
Dimensions	14.5 x 14.5 x 14.5 inches
Low Pass Crossover	50Hz - 150Hz
Phase Switch	Yes