17
Installation of the S7150 is a straight-forward process.
1. All Synthesis power amplifiers have been designed
to be mounted in EIA standard racks or stacked
freestanding.
Always put amplifiers on the bottom of a stack.
If the S7150 is being mounted in a rack, it is suggested
that its feet be removed prior to installation. If the
S7150 will be stacked with other components, use the
feet that came attached to the unit. This will ensure that
there is sufficient air space underneath so that heat can
be dissipated effectively.
2. Make sure that the amplifiers are located in a
well-ventilated, cool area. Be certain that the front
and rear panels are not obstructed, as the cooling
fan brings air in from the rear and expels it at the
front. It is very important not to obstruct the airflow
from the center front panel; heat buildup and
premature failure may occur.
5.0
PHYSICAL
CONSIDERATIONS
5.0
INSTALLING YOUR
POWER AMPLIFIER
To Next Page
Loading...
