VT X A12 | User Manual
11
3.1 - VTX A12 AF - ARRAY FRAME
• Array Frame for suspending VTX A12 enclosures
• 1 x Extension Bar included
• Built-in storage position for Extension Bar
• Single, front-to-back and side-by-side suspension points
• High-resolution single-point selection
• Support for up to 24 x VTX A12 (array geometry dependent)
• Included laser bracket for JBL VTX LZ, LAP-TEP and Recline
3.2 - VTX A12 AF EB - ARRAY FRAME EXTENSION BAR
• Extension Bar for use with the VTX A12 AF
• 2 x Extension Bar can be used for side-by-side suspension
• Support for up to 24 x VTX A12 (array geometry dependent)
• 3 x CM 5/8” Shackles included
• Lightweight design
3 - COMPATIBLE ACCESSORIES
For more information on the accessories, refer to the accessory specification sheets. For more information on usage,
refer to the VTX A12 Rigging Manual available at www.jblpro.com.
3.3 - VTX A12 SB - SUSPENSION BAR (PRELIMINARY)
• Compact suspension bar for VTX A12
• Connects to the top or bottom cabinet of an array
• Used to implement pull-back
• Used for suspending VTX A12 enclosures
• Support for up to 18 x VTX A12
• Lightweight design
CAUTION: Always use components and accessories specified and approved by JBL Professional. When a
cart is used, use caution when moving the cart to avoid injury from tip-over.
To Next Page
Loading...
