JBL VTX A12 User Manual

VT X A12 | User Manual
15
6 - VTX A12 CONNECTIONS
The JBL VTX A12 is equipped with two Neutrik NL8 SpeakON connectors. Both NL8 connectors are wired in parallel
and can be used as the system input or as a through connection for daisy-chaining multiple cabinets together. The A12
NL8 connectors are installed upside down so that the NL8 locking pin position can be seen from under the array.
VTX A12 internal NL8 pinout
NL8 Pin Pin 1 +/- Pin 2 +/- Pin 3 +/- Pin 4 +/-
Transducers A12 LF Left A12 LF Right A12 MF A12 HF
6.1 - VTX A12 INTERNAL WIRING
1+
1-
2+
2-
3+
3-
4+
4-
1+
1-
2+
2-
3+
3-
4+
4-
LF
MF
HF
CAUTION: Always use high-quality insulated speaker cables made by reputable manufactures. Keep cable
length as short as possible with sufficient gauge for the application.

JBL VTX A12 Specifications

General

Nominal Impedance	8 ohms
Horizontal Coverage	90 degrees
Input Connectors	Neutrik NL4
Type	3-way
LF Driver	12"
MF Driver	4 x 5"
HF Driver	3 x 2"
Enclosure Construction	Plywood
Coverage Pattern	90° horizontal
Drivers	LF: 3 x 12", MF: 4 x 5", HF: 3 x 2"
Enclosure Material	Plywood